I have found the adjustments for the forms and I did try to adjust them the issue comes in on the ecentric. I keep getting one side off the plate and then a fat stripe on the other, the other issue comes in is that the roller goes back off the plate if the distributer is not installed. I did know that the weight of the other rollers would settle in to the correct settings for the distribution of the ink throughout the ink rollers. I was hoping to find like a pdf that explained it in a little more detail along with the settings for the ductor. I have cleaned up the drips and hard ink all over the back side and got it to touch in most places but figured there could be a setting there also.
I could also use something to set the crestline watter rollers. This one has at least two settings. I have run a lot of different presses and I know how easy it is to start chewing up rollers if the settings are aoff even slightly. Thank You for your reply.
|
