Accuset 800 job time outs V2

[adam470]

Hi this is a continuation of this thread
Accuset 800 job time outs

I have reinstall the PAC pci card, RIP software and drivers
i have made a new cable using the pin out in the attachment which i copied from the old cable and I'm not sure if its correct or not
and i am still getting timeouts

i developed what was in the cassette their was more film than i was expecting with a lot of blank areas and this was the type of images i have got




plus the test page which looks fine

Thanks for any help

Adam

[VladCanada]

Borrow PAC board somewhere in Australia to be sure that's PAC board problem, adam470

[adam470]

thanks Vlad that might be a bit tricky i don't know anyone with a spare PAC board i might have to start a thread to ask if someone knows someone in Brisbane that can help

is there a service manual for them or any tests that can be done to diagnose any problems i mean if i gave to board to an agfa technician what would they do to test it

thanks

Adam

[TechDoc]

I still believe that the reason for this is the APIS Cable... before you did have only a communication Problem (Timeout), but now with your handmade cable it seems to have also a sync problem...
Why don´t you simple order a new APIS cable at Agfa ? The partnumber for that cable is normally printed on the cable ..

[adam470]

that would be too easy tech doc nothing has been that easy so far
the home made cable was a test to see if the original was the problem
i never did find the specifications for the cable so i may have just copied the problem
to the new cable the only way to know for sure is to buy a new cable but then i might
end up with 3 cables and the same problem

i will double check the home made cable and other connections give it another go if it doesn't work i will buy a new one if that doesn't work well then i will know for sure its not the cable

thanks for your help

Adam

[VladCanada]

99% of mine - APIS PAC/UPAC board problem

[TechDoc]

Just a question ... Did you ever run an offline Exposure Test page ?
To make sure that the problem is not within the AccuSet ?