Results 1 to 2 of 2
  1. 02-12-2011, 12:32 PM #1
    EPS
    EPS is offline Junior Member
    Join Date
    Jul 2010
    Posts
    6

    Default Antique proset 9400

    Is it possible to adjust leading(film feed amount) from the keypad of 9400? I replaced main film feed roller(rubber bad) with one that I had recovered at a roller co. Since then, an 11"x17" job feeds about 1/16" to much.(1/16" to long) Would that procedure, if possible, be in the operators manual?
    Reply With Quote Reply With Quote
  2. 02-12-2011, 05:45 PM #2
    VladCanada's Avatar
    VladCanada
    VladCanada is offline Senior Member
    Send a message via Skype™ to VladCanada
    Join Date
    Sep 2008
    Location
    Ontario, GTA, Canada
    Posts
    877

    Default

    Nope...
    That's a Service procedure described in Sevice manual at Capstan roller replacement procedure chapter.
    There is no pdf files available worldwide, just printed booklet (and I lost mine probably somewhere
    in prev. century )
    Last edited by VladCanada; 02-12-2011 at 05:48 PM.
    Reply With Quote Reply With Quote

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Sponsors

Esko Sponsored Content

WhatTheyThink Sites