Results 1 to 3 of 3
  1. 02-18-2011, 07:00 PM #1
    Eugenio07
    Eugenio07 is offline Junior Member
    Join Date
    Feb 2011
    Posts
    3

    Default Presstek Vector TX52 - Who can help?

    We bought a Presstek Vector TX52 (used) in December 2010. We were able to make plates on the platemaker until about a week ago when we suddenly had a problem.

    In the status box it says "OFFLINE". And it seems I can't get the the platemaker to connect to the rip computer again.

    I have tried lots. (after making a disk image backup of the rip computer)
    • Restarting and Restarting
    • New USB cable
    • Restoring the computer to a point when everything worked.
    • Reinstalling the rip software. (Presstek Momentum)
    • Installing the rip software to another computer.

    Is there anyone that could help me with this? Thank you!
    Reply With Quote Reply With Quote
  2. 02-18-2011, 07:22 PM #2
    VladCanada's Avatar
    VladCanada
    VladCanada is offline Senior Member
    Send a message via Skype™ to VladCanada
    Join Date
    Sep 2008
    Location
    Ontario, GTA, Canada
    Posts
    878

    Default

    You are on a wrong side of road.
    Look at Vektor as a problem source.
    Last edited by VladCanada; 02-19-2011 at 08:59 AM.
    Reply With Quote Reply With Quote
  3. 02-21-2011, 10:28 AM #3
    Eugenio07
    Eugenio07 is offline Junior Member
    Join Date
    Feb 2011
    Posts
    3

    Default

    If Vector is the problem source, what could it be? Would you suspect board where the USB cable plugs in?
    Reply With Quote Reply With Quote

« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Sponsors

Esko Sponsored Content

WhatTheyThink Sites