Luscher Queue Problem

[JSto]

We have a Luscher 160 that we have ran for almost 6 years with just one size plate. Due to a new press we now need to also image a plate that is 22 mm larger from lead edge to tail. We still use the Q2 spooler and I've created a 2nd queue for the new size but I cannot for the life of me see where you change the parameters to image the larger plate. Any guidance would be much appreciated.

[cmederas]

My friend, Q2 Spooler.

The size of the plate is in a file in a folder named plate.

You can find it in:

C://luscher/configuration/plates

The safe mode is to copy the one are you using and paste it, and change the size in this
file.

You should put the same name in the folder of the configuration of Q2, the queue and the file, this is important.

Good luck,