Canon 7000 Duplex problem

[srspdy7390]

On duplex prints there is always a discrepancy of .08" from one side to the other. Has anyone else encountered this and is there a (relatively) simple way to adjust this in the printer's settings?

[Prepress_Parasite]

This has been our experience only when the paper is not cut to the same length as the paper you did your initial setup with.
There is a setting for each paper that will let you set the scale/zoom factor. Make sure what you are printing out is also the correct width and height as I have noticed that the thinner stocks have a tendency to stretch/shrink unevenly front and back.

[Neal Anderson]

In your Properties, under Finishing, there is a check box titled, "Image Shift". Check this box and then adjust the image shift in the direction you need it to go. Good Luck.