Error at the end of the Exposure..???

[sistecopy]

Hi we have a problem with Metadimension 6.0.

After re install all the software on Power Edge 14200, because some virus cause damage to the hard disk array, I send jobs to the Prosetter 74 and I have this problem because only film 2 plates or I some cases 1 plate, and I need send again the rest of the separation plates.

Here is a image that the Metadimension reports.

http://www.softpressmx.com/Error.JPG

Also any knows the name of the program to see the process of the Prosetter and put news plates sizes and configure..? I think that called GUI or something like that..and where I can get it because the technical support says that give me the CD but I donnt have it...

Thanks

[AutomaticWork]

Use the Speedway EM from the Meta 6.0 DVD instead of the one from version 6.1.
You may have done an upgrade?!?

[sistecopy]

What do you mean..with EM..? to the driver or the SpeedWay Intallation Engine..

Thanks

[AutomaticWork]

Thats what I meant

[sistecopy]

Thanks a lot ...
I fix the problem...

Now you now where I can get the GUI software...When I buy the rip, I have it installed but I don't have the Setup or Cd installation..

thanks