Results 1 to 4 of 4
  1. 02-01-2011, 12:47 PM #1
    Epacal
    Epacal is offline Junior Member
    Join Date
    Nov 2010
    Posts
    9

    Default CP2000 Touch Screen

    Does anyone know how to calibrate the touch screen sensitivity?
    I show up in my plant in MX and they are banging on the screen to input sheet sizes.
    Thanks in Advance!
    Epacal
    Reply With Quote Reply With Quote
  2. 02-06-2011, 03:49 PM #2
    Michel Walinga
    Michel Walinga is offline Junior Member
    Join Date
    Jul 2010
    Location
    Netherlands
    Posts
    9

    Default

    If the machine / software is not to old....

    place your machine at stand stil! press the suction head on and plus and minus (+/-) at he same time (3 buttons at the same time (the air punp is getting on but you can simply turn it of again) If everything went ok you can calibrate the screen now...

    Michèl Walinga
    Tetterode Nederland bv
    Reply With Quote Reply With Quote
  3. 02-07-2011, 11:50 AM #3
    Epacal
    Epacal is offline Junior Member
    Join Date
    Nov 2010
    Posts
    9

    Default Touch screen

    Thank you.
    I also found another way. Start at the service screen. Open the right side control cabinet on the console. On the I/O board are 2 gel buttons. Press the bottom botton and a Heidelberg button appears on the service screen. Open it and there is a calibration button just follow the prompts.
    Reply With Quote Reply With Quote
  4. 02-01-2012, 09:02 PM #4
    Andrysetio
    Andrysetio is offline Junior Member
    Join Date
    Feb 2012
    Location
    Indonesia
    Posts
    3

    Default

    How to start with service screen with cp2000?
    Can I use mouse or keyboard to control the machine?
    Reply With Quote Reply With Quote

« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Sponsors

Esko Sponsored Content

WhatTheyThink Sites