Results 1 to 5 of 5
Like Tree2Likes
  • 1 Post By Drucker
  • 1 Post By Strezovski

Thread: Adjust presure between plate and blanket cylinder

  1. #1
    Strezovski is offline Junior Member
    Join Date
    Jan 2012
    Location
    Macedonia
    Posts
    6

    Default Adjust presure between plate and blanket cylinder

    How to Adjust presure between plate and blanket cylinder on heidelberg speedmaster sm 74 1995

  2. #2
    Cornishpastythighs's Avatar
    Cornishpastythighs is offline Senior Member
    Join Date
    Oct 2009
    Location
    Deans Bottom, Kent, UK
    Posts
    493

    Default

    please clarify Do you want to adjust the pressure loading of the plate and blanket cylinder bearer rings? I would have thought this should only be done by an experienced Heidelberg tech as doing this incorrectly could cause some very expensive damage to the cylinder bearers. If on the other hand you wish to adjust the 'Squeeze' between the plate and blanket then you need to adjust your press packings to obtain the best printing pressure that will transfer ink efficiently and give you the best registration.

  3. #3
    Strezovski is offline Junior Member
    Join Date
    Jan 2012
    Location
    Macedonia
    Posts
    6

    Default

    yes i want to adjust the 'Squeeze' between the plate and blanket. I put + 0.50 mm papper under the blanket go get good presure.

  4. #4
    Drucker is offline Junior Member
    Join Date
    Oct 2012
    Location
    Germany
    Posts
    1

    Default

    Last edited by Drucker; 01-14-2013 at 02:38 PM.
    Strezovski likes this.

  5. #5
    Strezovski is offline Junior Member
    Join Date
    Jan 2012
    Location
    Macedonia
    Posts
    6

    Default

    Thanks Drucker
    Drucker likes this.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Sponsors