Scitex Dolev 800 V Error

[kala]

Hi

When i switched on My Dolev 800V iam hearing a beep noise continuosly like interlock alarm in ctp.
I tried changing the cpu board and vga card after that also i got the same alarm sound when i start the machine also.
Kindly suggest how to sort out the issue.

rgds
kala

[PACH]

Hi

When i switched on My Dolev 800V iam hearing a beep noise continuosly like interlock alarm in ctp.
I tried changing the cpu board and vga card after that also i got the same alarm sound when i start the machine also.
Kindly suggest how to sort out the issue.

rgds
kala

Kala

Do you get any error messages? Can you boot up the Dolev?

[kala]

Kala

Do you get any error messages? Can you boot up the Dolev?

No error message without any error machine comes stand by mode.

Shall i try to expose some job when the alarm sound is keep on continuing? Kindly advice what to do?

rgds
Kala

[PACH]

No error message without any error machine comes stand by mode.

Shall i try to expose some job when the alarm sound is keep on continuing? Kindly advice what to do?

rgds
Kala

Kala,

I think that the alarm sound must be comming from the CPU board as this has a small speaker on board. There should be a jumper on this board that should be OFF ( not made) for the speaker.
If the Dolev comes to Standby than try and expose a job.

[kala]

Kala,

I think that the alarm sound must be comming from the CPU board as this has a small speaker on board. There should be a jumper on this board that should be OFF ( not made) for the speaker.
If the Dolev comes to Standby than try and expose a job.

Justnow I tried exposing small job it exposed without any error but still iam hearing the beep sound.
If iam not wrong u want me to remove the jumber on the cpu board or what to do??
Can i expose continuosly along with this beep sound. kindly advice

rgds
kala