Dolev800

[wpsy]

Hi, I have a dolev800 1998 but recently go problem that after 2 ouputs I need to have it soft reset the system if not I will then got an error of laser workpoint set error and laser extra current. Anyone who have idea to solve the problem. I had tried change the OMC but still the same.

[leo]

It may your laser is bad?
Have you tried to exchange another working Static Optic?

[wpsy]

Leo, thanks but I had change the static optics and still the same.

[leo]

You should try to check the CPU board

[wpsy]

By the way, I had also changed the CPU but no help.

[leo]

I'm sorry, how about cable? You should contact member "PACH" in this forum. He is expert, hope it help.

[PACH]

Hi, I have a dolev800 1998 but recently go problem that after 2 ouputs I need to have it soft reset the system if not I will then got an error of laser workpoint set error and laser extra current. Anyone who have idea to solve the problem. I had tried change the OMC but still the same.

WPSY,
The problem is the following: Static Optic assy cannot reach Diode work point so the next part to replace try the OMC board. If this does not help try again another Static Optics.
Good luck.

[wpsy]

thanks Pach, I had also replaced the OMC board again still the same. I am now trying to get another static optics to replace.

[leo]

thanks Pach, I had also replaced the OMC board again still the same. I am now trying to get another static optics to replace.

Have you replaced static optic and settle down your matter?