Mismatched Plotter expose lines

[gjjgolis]

I'm getting a mismatched plotter expose line required: 75120 DDB counted: 26496 error. This is on a Lotem 800 with a brisque in front of it.

It is only happening sporadically. It will run a few plates ok and then plot a third of a plate and then fail.

Can anybody tell me what they think the problem is?

Thanks
Jerry

[nemo]

Most common cause of this is the TSP in the Brisque or the DDB card but there may be other reasons too.

[gjjgolis]

Thanks for answering.

Is the DDB card in the Lotem itself?

[PACH]

Thanks for answering.

Is the DDB card in the Lotem itself?

YES. It is a BIG/EXPENSIVE board in the L Box which is behind the LHSide door. Even heat can cause intermittent problems. Open the LHS door; remove the 2 Alen screws that secure the L Box and gently pull out the L Box. Get a vacuum cleaner and clean under the box. There are 2 big fans on the top of the L Box that cool the boards . Maybe one of them is not working?