Prinergy Connect final output question

[tbowat]

We have a couple of presses that use plate sizes that are very similar and every once and a while a job gets plated for the wrong press. I see in the prinergy history that a warning will indicate the imposition and media do not match. I am wondering if there is a way that we could change the settings so the job would fail and not make the plates if the imposition and media didn't match?

Thanks

[Damdidam]

Hi tbowat,
yes, indeed, you could do that - but you need to have RBA.
If you work with press sheet size from your imposition application, then you would definitely use cut sheet in your plate output process template.
You could then write an RBA rule that would compare your impo size (value A) Vs the cut sheet size (value B). And fail the process if B is smaller than A.