Dolev 800 Error Messages

[dtermeer]

Got a Dolev 800 circa 1998.

On occasion I am getting a lot of errors when I try to image film. I can shut the machine off and sometimes get it to come back online and work for a while. But sometimes on startup ii will list some or all of these errors and then message "Not Ready"

Any idea what is causing these errors:

Rlyl power check err
Rly2 Power Check Err
Stepper 12V err
CRI driver error

[Aestiva]

Check for something simple, the fans to the right of the crate might clogged with debris and may not be working at all. Hope this helps.

[dtermeer]

Thanks for comment. I replaced the fans in August and checked the temperature in the electronics crate. I had heard from one source that the power supply may be going bad. Anyone have any experience with that.

[kala]

remove all the boards and reset the boards

[dtermeer]

I removed all the board in the electronics crate and reset them and that seemed to work for a week. I had no issues at all for the last seven days. Now the errors are all back and I can't get the system to get beyond them. Before, I could shut down the machine for 10 minutes, restart and it would come back online.

Any other suggestions?

[Tarun Chopra]

Check all interlocks are secure. We faced such problem when are interlocks in the small/medium film cassette area was not secure.

Hope this helps.

Regards

[dtermeer]

Check all interlocks are secure. We faced such problem when are interlocks in the small/medium film cassette area was not secure.

Thanks so much for the advice. You saved me a very expensive service call. The Cassette Interlock was bent and not triggered. The odd thing is that there was no Interlock error message among the 8 error messages that I got.

Thanks again.