Lotem 800 v image related error

[PACH]

If you did not reconnect the molex plug that drives that whell than the punch should not have moved from the position that you put in to.

Punch side .5mm decrease for eg instead of 33 now 32.5 mm ; need to increase .5mm on punch side... or decrease .5mm opposite...

after adjusting spiral punch gold wheel few plates (4-5) came perfect gripper afterthat again same .5mm punch side decrease???

Kindly suggest?

regards
kala

[kala]

I couldn'd understand your reply.. could u pls explain breifly...

I never removed any molex plug just rotate the yellow gold wheel that's it...

Apart from that what do u mean by molex plug .. connector or anything else send me the pix...

are explain me detail pls

regards
kala

[PACH]

Kala,
The Spiral punch has 2 motors , one that mages the spiral punch hole and the other that moves the punch forward or backward depending on the resolution of the job. If you are exposing at one resolution only i.e. Res100 than the spiral punch will saty in one position . So if you remove the molex connector that drives the punch backwards/forwards, do your manual adjustment of the hole by turning the brass wheel until the plate is square to your requirement. Like this the Spiral hole will stay the same every time it punches a plate.

I couldn'd understand your reply.. could u pls explain breifly...

I never removed any molex plug just rotate the yellow gold wheel that's it...

Apart from that what do u mean by molex plug .. connector or anything else send me the pix...

are explain me detail pls

regards
kala

[Nandomelo10]

PACH Lord, I'm from Brazil and I have the same problem, was exchanged laiser diode. Entire job now duplicate this recording, forming a spare lines, I think the default is attracted laiser was made test 4 in 4 laisers work comes out perfect. DDB was exchanged and not resolved with 24 diodes. How can I fix this defect, noting that doing the calibration uniformity escalinha 24 diodes, diode between 8:09 are about each other. Can you help me please.

[kala]

Kindly provide a image / file describes ur problem.. to give a solution..

[PACH]

Kala,
First you never told us how you got on with the out of suqare images on plates on both Lotems?
Nandomelo, You description of your problem is not clear of what was the original problem and step by step what was done on the Lotem to rectify it.

Kindly provide a image / file describes ur problem.. to give a solution..

[kala]

Patch after changing the suckers and did fine adjustment the gripper problem was solved which i replied a month before.. (Hope u meant that only)

regards
Kala