Results 1 to 4 of 4
  1. #1
    crossroads is offline Junior Member
    Join Date
    Nov 2012
    Location
    United States
    Posts
    19

    Default Old spinnit paper drill.

    I picked up an old lassco spinnit paper drill from a downsizing printing business. The drill seems to be doing a good job with the bit that came in it. But I canot figure out how to take out the old bit and put in a different size. Does anyone have experience with 1 of these? any help will be appreciated.

  2. #2
    GuruMorgor is offline Member
    Join Date
    Mar 2012
    Location
    Ellwood City, PA
    Posts
    42

    Default

    Might be held in there dynamically if its anything like the one we have. Should be a hole in the chuck above the bit that you stick a tool in and twist and the bit pops out.

  3. #3
    ondemandbindery is offline Senior Member
    Join Date
    Mar 2008
    Posts
    312

    Default

    Unless this drill is different from all others I have seen and used in the Boreshaft where the bits goes there will be a hole in the shaft just above where the drill bit stops. Maybe a 1/4" hole. Stick some type of solid piece in the hole and pry down.

    Now if the drill is really old and it has been in the machine for a long time getting it out may take some affort. PB Blaster, maybe some heat and patience will get it removed.

    Good luck,
    JW

  4. #4
    crossroads is offline Junior Member
    Join Date
    Nov 2012
    Location
    United States
    Posts
    19

    Default

    Thanks a lot. I will try that in the morning.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Sponsors