Kodak Magnus 400 - plate count?

[JenC]

Does anyone know where to find a plate count history in the Creo interface for a Kodak Magnus 400 platesetter? We were unable to locate any physical counters on the actual machine. Thanks!

[curiosity]

Tools / general

We use the Magnus 800 Controller Software v 1.07.409.023, but maybe the 400 doesn't have the same interface.

[JenC]

The Magus 400 has "Kodak RSS Client", version 2.2.6 at the front end. Tried to find a Tools/General section, but the interface is different than the 800, unfortunately. Thanks for response, though.

[PACH]

The Magus 400 has "Kodak RSS Client", version 2.2.6 at the front end. Tried to find a Tools/General section, but the interface is different than the 800, unfortunately. Thanks for response, though.

Hi JenC

How old is your Magnus? If it is an older version than open the "Loading system" and at the bottom left hand side you should see the number of plates that went through the Magnus.

[JenC]

Got it! Thank you!

[PACH]

Got it! Thank you!

I am pleased that I managed to help you.