Recent content by DGaynor56

I believe you need to post bake the Electra plates when using UV inks

Open door Open door Sounds like there is an open door situation. The safety loop is directly related to the laser being in an unsafe situation. The are multiple different ways this can be triggered but the most common is an open door/cover.

DG DG I think Mark ha it right. It is probably the Mother board capacitor. They were a real problem in the matchprints, If you open up the computer and search the mother board you can probably see the bad cap. It is bowed on the top instead of flat. Their monitors had the same problem.

If you hear the motor running on your debris removal, you may have a clogged hose to the thermal head. Also, double check the cables to the unit to make sure everything is plugged in. If the green light goes on and there is no sound then it is the blower. Without access to the firmware, you cant...

You are getting a light valve error(LV) which is inside the laser. It could be a number of issues. Laser error or power supply are the most likely. You also might want to check if all of the doors are properly closed on your trendsetter. It could also be one of the cables that connect the...

I think it is important to be honest your customers and not try and deceive them. As with any electo/mechanical device there is a lifespan. Let tham know where they stand.

coolant circulation problem coolant circulation problem It is very important that you get the cooler(chiller)replaced. I have seen this cause major problems with the laser. It is a common occurance. If you have any further questions or any assistance in the replacement of the chiller, I would...

MCEs are licensed with a dongle