Recent content by eceteknik

error-1 is for old type hope (gl series) processors. it means developer low level. error-2 is fixer low level. error-3 is water low level.

check the medium roller? it may need be replaced.

look. this is another error. if in the morning first film doesnt enter, then your loading rollers are melted. which film supply cassette (s) did you try?

your film stuck in conveyor problem may have several causes. can be incorrect leveling between Dolev and online processor. may be humidity problem together with incorrect leveling. because the first film stuck and the others pass.

in case you want to use harddisk. it must be less than 1GB clean IDE harddisk (difficult to find). verify it is working on any PC. connect it via IDE cable to the corresponding slot on your dolev's Cpu board. turn on dolev. go to BIOS at startup and check that it is configured. if not, configure...

insert a blank high density diskette into your pc diskette drive. format it. extract the zipped file and see the exe file. double click it. it will ask for diskette. press enter. and wait for installation finished.

if theres no error messages, it is shutter problem.

dolev 800V firmware

thats an exe file how can i post it here

i need your e-mail address to send the file nitesh.

give me your mail address please.

of course offline use of Dolev 4press is less problematic, sometimes you face ACC buffer too large. But most of customers want to use online. they don't like to cut the film roll. especially newspaper companies. The dolev 4 press needs two times a year service visits. the rollers and springs...

it looks like your ethershare host configurations are mixed. can you send ping from any network computers to the brisque. if yes, give me a teamviewer connestion from that computer and i try to fix it remotely.

i think it is 43p platform. thats memory problem. unsupported DIMM. remove the unsupported DIMM. you can test your memory modules one by one.

major reasons for that, sticky rollers, loose springs. if you fix them you can run your machine with default motor prm.