Recent content by NorwoodPress

Our have prices have gone up too here in the UK. Now £3.17 per plate :oops:

I don't buy in pre-collated sheets, because I've never liked the idea if you get a jam. Plus as we do a lot of ncr pads, using various coloured sheets, it's cheaper for us to buy in SRA3, compared to pre-collated (especially here in the UK).

It would be interesting to see samples, especially of solid colours like you said with no banding

So I've got a 3 part ncr that is black & white, double sided and is numbered. I get 2 up on a sheet as it's A4 on SRA3 sheet. I'm pulling from tray 5 for white top sheet, tray 6 yellow middle sheet and tray 7 pink bottom sheet. So there would be 1,875 sheets per each coloured sheet. Totalling...

Yes it turned out to be the ROS window covered in toner dust. At least I now know how to strip the machine apart.

Has anyone else ever had a dent appear on there IBT belt? Not sure what would have caused that. Currently awaiting for an engineer to come out to replace. It was interesting to see how the toner gets put onto the belt. I see that it puts down 3 solids strips of colour in-between each job. No...

I am currently getting a white solid line going across my prints. I did a CMYK test to see if it's a drum. Well it only appears on Cyan, so I swapped the Cyan drum around with the Magenta Drum. Still getting the same white line in the same place, so surely can't be a drum issue, as it should...

These are other fault codes in history

I had this same issue on my Versant 280. Sometimes it can be the pressure roller, but on this occasion it was the fuser.

Does anyone else experience the following Fault code 026-401 on their Xerox Versant 280? I seem to get it now and again, its to do with alignment threshold going out.

I have ran C5 and C4 peel and seal envelopes on our Versant 280 and ran ok.

I did speak to my sales rep and he did tell me that apparently the 2nd BTR's are being manufactured in Ireland and they have opened up another factory to cope with demand. So perhaps that might be why you can get them quite quick. I have tried to place another on order as a spare.

I fully agree, does make you think what is Xerox actually trying to do? I mean it must be costing them a fortune in producing and shipping the 2nd BTR parts :rolleyes:

Most engineers I speak to, all admit the problem does exist, but there is 1 or 2 engineers who try to go down the route of saying to use Xerox paper :rolleyes: which is twice as much, but at the end of the day paper is paper and most all come from the same paper mills here in Europe and Far East.

No, we were looking at a remanufactured 3100, apparently only done 3 million clicks which is low for this machine they say. It's just the 2nd BTR issue which kind of puts you off if it's the same issue on all the machines. Now I was looking at Richo, but I have been told their service for...