Recent content by REHSR

Sounds like the same issue I had when moving one my units and rearranged the print room. Even though it shouldn't matter these days. I used a standard CAT5 end to end cable. I found by replacing that with a CAT5 Crossover cable problem was solved, seems some of the older units have finicky...

I think because I caught it quickly. Unit never presented any error codes or stopped. Running fine now except the occasional squeak from the upper right corner. Looking into that now.

Found it Slip sheet was shot. Both wicks were dry, lots of buildup. Cleaned unit replaced, belt, slipsheet and wicks. Running like new and a lot cheaper than entire new assembly. Thanks again for all your support.

I cannot see any external problems with the fuser however it appears to be the problem. I ran and stopped over a dozen sheets at various stages and no marks before going in the fuser. Once they exit the fuse I have marks. Unit is very hot at the moment I'll let the system cool down and pull the...

azehnali, My apologies I was called away on an emergency. As you suggested I ran serval copies and stopped the image just before the fuser. Pulled the IBT Drawer and rotated the belt counterclockwise. No Marks on the image. Seems odd as prior I had the marks on the image pre fuser. Ah but wait...

azehnali, Here's a picture we have seen before. Sorry but all I have is my phone this afternoon. But when you zoom in see all the lines in her shoulder and hair. They actually run full length of the image. They appear as indentations, but you can't really feel them. You can see the deepest one...

azehnali, Thank you for the suggestion. I ran serval pages and stopped them as you suggested however the line is there before going into the fuser. Again, I ran a full color page or each color to rule out Drums or contaminated toner. If I'm thinking correctly if it were in the ROS, it wouldn't...

Unfortunate update, I'm back to Square One. Tech just left after checking Transfer Belt, 2nd BTR, Fuser, replaced all 4 drums. Cleaned both ROS units. Said that it was normal for the V-180 because not enough humidity in the room because, I had it shutdown. Once again telling me to use Xerox...

I was thinking about that, I went through, the whole ordeal with Xerox and having to use Xerox Paper and room must be 65 % humidity. After a year of battle finally found a reliable stock and a happy medium with the humidity. Now thinking about it, I was gone for 4 days, and shop was closed up...

Yes, I do all my own service to many problems with X Tech

2nd BTR is very clean and smooth, checked both rollers and the cleaning strip, no marks or damage to any of them. I'm considering buying one of the steel rollers for the 2nd BTR as 90% of what I run is all coated stock. I'm told they make a big difference in 2nd BTR. But don't anyone who has...

Looking for some guidance PLEASE, Versant V-180 suddenly I have marks one side of my prints. IBT Belt looks great, all drums are between 80-95 % All Toners are 70% plus. I only use OEM Xerox Toner and Drums Switched drums around (no change) Tried switching paper stock. They appear on Uncoated...