Search results

To change the language back to English: Press "Offline" - lower left button Press "User Maintenance" - fifth button from top Press "OK" - bottom center Press "ETC" - 8th button counting left to right, top to bottom Press "OK" - bottom center Press "Language" - fourth button from top Press "OK"...

It could be something as easy as the set screws on the M24 gear are loose, causing the tail clamp lock to not move.

Yes, the drum dimensions are different, both diameter and width, hence the different plate size. But, what you are overlooking is the energy required to expose the plate properly. The spec calls for the lasers to apply a precise amount of energy to the emulsion. That energy is expressed in drum...

The larger machine will be slower because the recording head has to traverse the entire width of the plate. Drum speed maximum on both machines is (I think) 1000 rpm

If all else fails, try this product: Mac Windows File Sharing - Connect Mac to Windows Server - GroupLogic I have seen it work wonders.

Quick check of the lead screw moter encoder lamps. Rap on the end of the lead screw motor with the handle of a screw driver two or three times sharply. Sometimes a bad connection developes in the lamp connectors. I have seen this bring the traverse back to life. By no means is this a fix...

To remove the panel, you must remove the lower front panel and the left (away) side panel., then you will see the screws that hold the lower left panel on. Speaker is in the upper right. The last one I looker at was black, maybe 1.5 inches square. If it's adjustable, there will be a small...

I don't believe the notification can be turned off. Earlier 4300's had an adjustable beeper with a vloume control in the upper left corner of the beeper itself. Later ones have a non adjustable and obnoxious beeper. Packing tape over the speaker quiets it considerably. The beeper is located...

Humidity, humidity, humidity. When selecting a humidifier, it is best to stay away from the ultrasonics. Most of these devices will emit a very fine powder (minerals in the water), this powder will get into even the most sealed areas of your platesetter and give you even more headaches than the...

Have you gotten any errors? If, when the Acento exhibits this problem, can you output test images from the Control Panel? Specifically a Grid Pattern? If you have no errors and can output a Grid Pattern, the issue is most likely with the front end.

If you want to get good and close without straining your eyes, check out this scope. Carson ePix Digital Microscope MM-640 FREE Shipping Microscope Digital Camera Pictures Video As an added bonus, you can capture the image and email it for troubleshooting purposes.

You are correct, the Fuji plates don't ablate much, but there is still some. Wouldn't hurt to inspect the final lens about once a month. If it were my machine, I would check it every time I cleaned the external air filter. Much cheaper than replacing lasers.

It also depends on the plate type, ie, Kodak, Fuji. Some plates ablate more than others and can coat the final lens more quickly.

It's possible that your Epson and another device on your network have the same IP address. Discover what the IP address of the Epson is , then unplug the network cable and "ping" the Epson address.