Search results

Hi Adnan, I have encounter similar behavior in past. Problem could be related with power supply for security loop. Everything seems to be OK for a period of time and suddenly machine gone crazy. I found that a fan on power supply is stuck and module slowly is heating up until enter in...

"If not let him to die, will not let you to live" Same story everywhere. Eventually we will buy "fresh bread" made in PRC.

Thanks for link, FM screen was my first choice but can not be generated using on different x and y resolution. I try on press 450 Lpi but colour shadows are limited.

Hello guys, Have any idea about screen ruling and angle for lenticular printing? Assuming an average job like: Input: - 16 images at 300 dpi - Visual pitch 76.125 lens per inch - Interlaced output tiff at 1218 by 1218 dpi Output: - CTP continuous variable resolution - across the lens 2400...

Old hobby it is on hold (a tube audio amplifier and some interesting type of loudspeakers) because every afternoon I get same request: "daddy, daddy, come and play with me!".... so my new hobby is Lego Star Wars, Lego Indiana Jones, Lego factory and other Lego stuff.

Could be temperature related. Try to put a small fan to blow direct on TSP board. Also check in Dolev the fan condition. On lower left side on back.

Hello Alvoeiro, There is a problem with spinner encoder. Weak diode, dirt disk, misalignment. Ask for professional support on local dealer. You can try a plot at lower spinner speed. Regards

For sure 10 microns spot size in too much for this media. Imaging is a double burn ablation process (heat emulsion two times until it is blowing off the substrate) and 10 microns become less then 10. Assuming that small rasters dots are still on the media, copy process will wipe any singular...

Hi Andre, I know, but.... it's a litle bit faaaaaaar away (about 4700 miles) in East Europe and device will be installed later in July. Please note: DITR can be installed on mark II, III and IV Trensetters (those devices allow double burn of media) and need NOT to have autoloader. Also you can...

Hello guys, You can output film on any Trendsetter 8UP device (using Kodak DITR film). It is only one requirement to have external vent mounted on debris removal unit (a simple tube routed outside the building). Of course media should be properly setted in device. You can have FM screen with 25...

Prinergy EVO TDL is just an TIFF shooter to CTP. Set it and forgot it. It will not make you any trouble. Trendsetter also will not make you any trouble, just don't forget the maintenance. Most of the problems come from the plate processor. Don't take a cheap one!

Hello Fii, When is happen? At the be beginning of plot or during plot? In the Lotem interface what error is?

Hello there, I am Liviu, right now I am service engineer for a local dealer of prepress equipment in Romania. I start dealing with Mac - PC networking back in '90, from there I jump to DTP, later in prepress, digital press operator and now I deal with Scitex/Creo/Kodak CTPs, workflows...