Search results

Eco sol inks make some vinyls edge curl unless you laminate them.

Many different roll media. Adhesive vinyls, synthetic and other papers (even bond paper), phototex, backlit films, frosted window films, 0.5mm magnetic sheet, PVC banner etc etc

Excellent choice. We've had a 1650 for years and still love it.

To eliminate profile issues run the print again without any colour correction. As others have said, check head height and nozzle function.

Vehicle magnet sheets are usually thicker than fridge magnet stock so check that.

Speeding up the printer will normally change colour - you should really reprofile for accuracy if you do that.

It should be fairly simple to make a Spot 1 layer with those percentages of white in Illustrator. Or have 2 layers - 1 at 30% and another 100%

We trim on a Zund so not a cheap setup but you can crank out some posters

We could get close to that on 130gsm on our Colorado for qty 100. A bit more $ for less qty. We're in Sydney too.

They better be cheap cos that market is brutal haha

Sure

What RIP are you using? I know in Onyx you can add a compensation factor to allow for this kind of problem. You print a line then enter the measured length then it adjusts every print afterwards.

Unless you have broad experience in signage I'd say it would be a headache

I don't know about screens but a true flatbed is very accurate for repeatability. Belt fed printers, not so much.

Ah HP latex. They never print the same length, or colour, twice

We have Engview. It's full featured (read expensive) but we really only use the libraries, the files of which are customisable.

I'm not sure why you'd want to do this. We've always just loaded the printer takeup roll staright into the laminator. I must be missing something.

Not sure mate. We only use Cutserver to send cut files to our Summa vinyl cutter. Maybe ask Onyx support or your dealer? We have a Zund flatbed cutter which has it's own software. Pretty sure lots of sign folk use Colex cutters so I'm sure there's a simple solution.

We've had Arizonas for years. They are reliable, stable printers. They can need calibration if you start to notice blurry or out of registration prints. Sometimes this happens after a head strike or similar. When this happens it's an Oce technician who performs the calibration, not the user...

In our version of Thrive it has the option to add the marks for a Colex Sharpcut in CutServer. Maybe that works. Note before printing you need to select the cutter in Job Editor or Rip Queue.