PrintArtPrePress
Member
I have an issue with imposed jobs that I have sent to plate. Not noticing it until it gets out to the cutter, but it seems as though the image actually stretches ever so slightly (less than 1/32) across the sheet.
We are running Rampage 11.2 (just recently upgraded), and are imaging plates through a Javelin. I output a plate directly from the Javelin (just a grid) and there is no stretching. Which leads me to believe the problem lies in Rampage itself... the vertical and horizontal scales are both 100% in the plot que. I spoke with Rampage tech support, and they have never heard of this and besides the horizontal and vertical scales in the plot couldn't help much.
Perhaps I am crazy! But I am hoping that maybe someone out there had a similiar problem or had a suggestion as to where I can begin to even try to solve the problem.
Thanks...
We are running Rampage 11.2 (just recently upgraded), and are imaging plates through a Javelin. I output a plate directly from the Javelin (just a grid) and there is no stretching. Which leads me to believe the problem lies in Rampage itself... the vertical and horizontal scales are both 100% in the plot que. I spoke with Rampage tech support, and they have never heard of this and besides the horizontal and vertical scales in the plot couldn't help much.
Perhaps I am crazy! But I am hoping that maybe someone out there had a similiar problem or had a suggestion as to where I can begin to even try to solve the problem.
Thanks...