Standard Finishing
4Over

Announcement

Collapse
No announcement yet.

My Ideal 5221 guillotine adjusts itself?

Collapse
Canon
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • My Ideal 5221 guillotine adjusts itself?

    My Ideal 5221 guillotine adjusts itself?

    I adjust the blade as normal, (with an adjustment screw at the side of the machine, to bring the blade in to contact with the cutting stick) but within 3 cuts it's no longer cutting the last sheet or two.

    On closer inspection with the covers off I can see as the blade hits the cutting stick the thread of the adjuster is turning fractionally, (un-assisted) as if there is not enough resistance in the thread to prevent it turning.

    Any Ideas would be appreciated.

    Harvey

    Edited by: Harvey on Jan 10, 2008 7:43 PM

  • #2
    Re: My Ideal 5221 guillotine adjusts itself?

    not seeing what kind adjusting screw you have. try backing it off a little and adding some lock tite or other thread locker then readjust.

    Comment


    • #3
      Re: My Ideal 5221 guillotine adjusts itself?

      Thanks Rob,

      Loctite is getting me out of trouble.

      Comment


      • #4
        Re: My Ideal 5221 guillotine adjusts itself?

        great, good luck

        Comment


        • #5
          no you must adjust. but you must manual for to do it. If you do not have
          email me
          ercupa@turbonett.com.ni

          Comment


          • #6
            Dude, stop filling up the front page with 6 year old posts...

            Comment

            4OverStandard FinishingDuploSmartsoft (Presswise)AleyantCanonKBA
            Standard FinishingDuplo

            What's Going On

            Collapse

            There are currently 5127 users online. 103 members and 5024 guests.

            Most users ever online was 6,597 at 10:25 AM on 04-20-2018.

            Working...
            X