Polar 76 EM LMS display same and backgauge comes too slow.

kazimates

Member
On Polar 76 EM (LMS system) when we turn on device and says to backgauge to front or rear it just goes to front and the lms value comes to display. When we give a command to the go to rear it try to comes to front. If we remove the lms cable from daughter (DB9 male connector) board or on lms black box (6 pin female jack) and we turn on the machine. without lms value the backgauge can be go front or rear in normal speed. What is the problem at here?
 
Hi sir, Good day LED Basic Signal Function with "led 'on"
Test this in the board SPE; LED VI =OFF When the main computer is initial phase(is LIT up for aprox f 1 sec
after the control voltages is ON.
LED V2= OFF error signal in the Main Computer
back to me any question
[email protected]
 

PressWise

A 30-day Fix for Managed Chaos

As any print professional knows, printing can be managed chaos. Software that solves multiple problems and provides measurable and monetizable value has a direct impact on the bottom-line.

“We reduced order entry costs by about 40%.” Significant savings in a shop that turns about 500 jobs a month.


Learn how…….

   
Back
Top