Standard Finishing
4OverXerox

Announcement

Collapse
No announcement yet.

Polar/Mohr 137EMC not accurate

Collapse
Canon
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Polar/Mohr 137EMC not accurate

    We have a Polar/Mohr 137EMC Cutter that is not cutting accurately. When set at 5" it cuts at slightly less (approx 4.97") and when set at 50" it is considerably over. Closer to 50.125". Anyone else run into this issue?
    If all the world put their problems in a hat, you would want to pull your own back out!
4OverCanonKBAAvantiXeroxSmartsoft (Presswise)Duplo

Automation Article

Collapse

Avanti
Why Would You Ever Want To Automate?
It seems far too complex, costs money, involves a lot of people, will take time etc etc. And then you run out of excuses. Read the article.

Standard FinishingDuplo

What's Going On

Collapse

There are currently 5886 users online. 96 members and 5790 guests.

Most users ever online was 6,611 at 11:23 AM on 02-27-2019.

Working...
X