Avantra 30 short olp error

[gicbelgium]

Dears,

This error message appears as soon as I switch on the processor : TS3 : 1

Does anyone know what that means?

Thx!

 

[VladCanada]

Dryer temperature sensor is broken.
ERROR TS3 :1 ( Bad contact )

 

[gicbelgium]

Thank you very much Vlad! Greetings

 

[gicbelgium]

Hello,

I just get new error messages on this short olp :

The first one is : Error M1:3
The second one is : Motor runs slow

I check voltage sent to the motor : +/- 24 to 26 volts... Ok
I change the opto interrupter with a new one... the error still appears.

Does anyone know what that means?

Thx

 

[VladCanada]

Probably you have motor carbon brushes worn out.
Anyway the problem is in the motor, if it runs slow or does not run at all.
Why not to find Ellie Loosen or Frank Ceulemans - the best former AGFA Belgium trainers in that equipment?

 

[gicbelgium]

Thx for tips Vlad.
I sent you a PM to explain my position.

 

[pam_add]

i'am always clean sensor of motor it work always