Standard Finishing
4Over

Announcement

Collapse
No announcement yet.

Avantra 30 problem

Collapse
Canon
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Avantra 30 problem

    Helo everybody,
    Please anyone can tell me if the avantra 25 DEC board can work in avantra 30.
    Thanks in advance.

  • #2
    Agfa Avantra 25 DEC board is not compatible with Avantra 30.
    Peter Warzecha | Viprofix
    pwarzecha@viprofix.com

    Comment


    • #3
      Hi,
      PeterW thank you for your reply.

      Comment


      • #4
        Finally I got another DEC Board for avantra 30 for and replace it but the proble I had did not change.
        And the second board it was working where I got it from.
        In fact the problem I have is this :
        When I image from the RIP there are strange lines coming in the image and if I do internal test of the
        machine there is no change.
        What else can cause this?

        Comment


        • #5
          Did you try to replace the communication cable from the rip computer to the imagestter?

          Comment


          • #6
            Hi,
            Yes I have changed the communication cable between the imagesetter and the RIP but no change.
            Now I think about to change the Carriage board CSDM,what do you think?

            Comment


            • #7
              I a not familiar with Agfa equipment, but it seems logical that if the internal test pattern comes out OK, than you should look further away, most likely outside of the imagesetter.
              The board in the RIP computer, the communication cable and all connectors become the obvious suspects.

              Comment

              4OverStandard FinishingDuploSmartsoft (Presswise)AleyantCanonKBA
              4OverStandard FinishingDuploAleyantCanonGraph Expo4 PeesLabelexpoKBAKBA

              What's Going On

              Collapse

              There are currently 5383 users online. 117 members and 5266 guests.

              Most users ever online was 6,597 at 10:25 AM on 04-20-2018.

              Working...
              X