Hello.
I have a problem with nip roller motor which is not working.
Checked so far:
1. Motor
2. Motor cable
3. SDM
4. Flat from DEC to SDM.
Still no 24V on the motor, nor on SDM output.
Unidiag gives "command error" when testing this motor.
Avdiag gives "APIS command error" when testing this motor.
Any ideas except "replace DEC"?
Cheers, Chris
I have a problem with nip roller motor which is not working.
Checked so far:
1. Motor
2. Motor cable
3. SDM
4. Flat from DEC to SDM.
Still no 24V on the motor, nor on SDM output.
Unidiag gives "command error" when testing this motor.
Avdiag gives "APIS command error" when testing this motor.
Any ideas except "replace DEC"?
Cheers, Chris
Last edited: