No announcement yet.

Conversion from U.S WebCoated (SWOP) to IsoCoated V2

  • Filter
  • Time
  • Show
Clear All
new posts

  • Conversion from U.S WebCoated (SWOP) to IsoCoated V2

    I have a pdf with an U.S. Webcoated(Swop) output intent.
    This has a yellow square wich is 4% c, 0% m, 94% y, 0 black.
    When i convert this to the IsoCoated profile, i get different colorvalue's: 8% c, 0% m, 86% y, 0 black
    I did this conversion with GMG Colorserver.

    Is it correct this way? Because the yellow become's much greener this way.

  • #2
    You're probably using perceptual rendering intent. Try relative colorimetric.

    Mike Adams
    Correct Color


    • #3
      I tested the L*a*b* values quickly in Photoshop using AbsCol rendering intent:

      Original colour values = L83 a-8 b76
      New colour values = L87 a-8 b75

      They are both as green as each other and almost as yellow as each other, the major difference being the L value... Despite/independently of Lab values, I don't think that cyan is good when you want yellow, a little magenta would be better (this being an artistic viewpoint and not a scientific one).

      Relative intent gives different numbers in the above test, with the green being the same with more variation in the yellow.

      Stephen Marsh
      Comments are personal and my views may not be shared by my employer or partners.


      • #4
        Did you create your own MX4 in GMG?


        Standard FinishingUltimate Smartsoft (Presswise)4Over

        What's Going On

        There are currently 2962 users online. 52 members and 2910 guests.

        Most users ever online was 5,872 at 11:39 AM on 09-30-2016.