To make a long story short: Jobs are running fine. Pressmen are printing to density and the press sheets are looking just like the proof.
Job after job after job after job.
Then suddenly, Cyan goes berserk and blows it all out of the water.
The proofs look fine, the plate measurements are fine, but they have the cyan shut off on the press and it's still 25 high. Our cyan press density should be 1.35 and they are running at 1.59.
? Any thoughts ?
Job is 4c PDF from a good, knowledgeable client, treated the same way all the other jobs are treated, it goes thru the same channels that every other 4c job goes thru.
Rip: Nexus
Proofing: GMG to Epson 9800
Plates: Fuji on Javelin 8600 S
Job is running with Concentric Screening. We haven't had any trouble with it .
Everything but the press looks to be right where it should be.
And, of course, I have to spend the rest of my day figuring this out.
Thanks in advance for any and all input!
Job after job after job after job.
Then suddenly, Cyan goes berserk and blows it all out of the water.
The proofs look fine, the plate measurements are fine, but they have the cyan shut off on the press and it's still 25 high. Our cyan press density should be 1.35 and they are running at 1.59.
? Any thoughts ?
Job is 4c PDF from a good, knowledgeable client, treated the same way all the other jobs are treated, it goes thru the same channels that every other 4c job goes thru.
Rip: Nexus
Proofing: GMG to Epson 9800
Plates: Fuji on Javelin 8600 S
Job is running with Concentric Screening. We haven't had any trouble with it .
Everything but the press looks to be right where it should be.
And, of course, I have to spend the rest of my day figuring this out.
Thanks in advance for any and all input!