Paultheprinter
Well-known member
Hello again,
ive recently posted a question about TAC and recieved some good advice. I have taken an opportunity to go through the rip settings today while the other staff tried to get me a decent set of plates out without trapping issues. I found a page where you enter the information and under a heading of colour management there is a pull down window which lets you chose input and output profiles. These were both set to Adobe CMYK which i assume means theres no output profile, looking through these pull down menus i find a euro coated and a swop v2 coated profile, if i were to select these as a output profile would this reduce my TAC?
Is this wise?
Paul
ive recently posted a question about TAC and recieved some good advice. I have taken an opportunity to go through the rip settings today while the other staff tried to get me a decent set of plates out without trapping issues. I found a page where you enter the information and under a heading of colour management there is a pull down window which lets you chose input and output profiles. These were both set to Adobe CMYK which i assume means theres no output profile, looking through these pull down menus i find a euro coated and a swop v2 coated profile, if i were to select these as a output profile would this reduce my TAC?
Is this wise?
Paul