Hola,
I used Harmony 7 years ago, sorry if I am asking the obvious.
I currently am making press curves with 23 steps. Had the pressman run it to density only and we read of the values using a X-Rite 500 Series Spectrodensitometer. I then made a new calibration/derived curve and set my target curve to 23 nodes. I then applied the readings into the calibration curve (CMYK). We ran a second sheet to density again and i need to make some slight adjustments, do I make these adjustments to the target curve or the calibration curve. Also there is a topic here that suggest we should not use a plate curve. A fuji tech made it during our switch to ecomaxx plates, so there was one applied. should I restart without the plate curve?
Thank you in advance.
I used Harmony 7 years ago, sorry if I am asking the obvious.
I currently am making press curves with 23 steps. Had the pressman run it to density only and we read of the values using a X-Rite 500 Series Spectrodensitometer. I then made a new calibration/derived curve and set my target curve to 23 nodes. I then applied the readings into the calibration curve (CMYK). We ran a second sheet to density again and i need to make some slight adjustments, do I make these adjustments to the target curve or the calibration curve. Also there is a topic here that suggest we should not use a plate curve. A fuji tech made it during our switch to ecomaxx plates, so there was one applied. should I restart without the plate curve?
Thank you in advance.