Anyone know any board that can be printed on with 7800/ 9800

[dub]

Does anyone know of any board that can be ran on an Epson 7800 or 9800 that is about .5mm or .019" thick. The primary purpose would be for structural mock-ups for packaging vs. our current method of printing on proofing paper and spray-mounting to board and then cutting on our cad table.

Trying to save some steps and reduce some materials.

Any suggestions?

thanks,
Dub

 

[meddington]

I did some tests a while back using actual packaging board with that thickness that was coated for inkjet use. This was from The Whole Proof (financial ... I've heard they've changed names, but the website is still up). This was actually roll fed on the Epson (4000 in this case), so it had a bit of curl, but it was workable and it profiled well.