Standard Finishing
4Over

Announcement

Collapse
No announcement yet.

Man Roland scanning densitometers

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Man Roland scanning densitometers

    We are a Man Roland shop and when I go out and do press proofs
    I am using a XRite 528 for checking densities, our presses are set up for status E and I would like to change
    them to status T. Is this possible from the console and or printlink ?

    Thanks

    John R

  • #2
    Re: Man Roland scanning densitometers

    I don't think you can, John, but you can switch your 528 to read Status E. That way you and the pressmen are playing in the same ballpark.

    rich

    Comment


    • #3
      Re: Man Roland scanning densitometers

      Thanks Rich.....Guess I just have to read the manual on the 528 to change it

      It was really the press room that was asking, its not a big deal....they just have to trust me !

      I'm going to leave it as is.....Im a status T type of guy.

      John

      Comment


      • #4
        Re: Man Roland scanning densitometers

        I'm afraid that the Status E readings on the Roland don't line up with Status E from a 528. It may be the Roland's polarization filter, I'm not sure, but the Roland readings will be quita a bit higher (About 2.0 on average) in all 4 colors.

        Best approach is to get a sheet with proper densities according to the X-Rite then set the corresponding Roland readings as your targets.

        Glenn Andrews
        Glenn Andrews
        www.colorclarity.net

        Comment

        UltimateDuploSmartsoft (Presswise)Standard FinishingKBA4Over
        UltimateDuploStandard FinishingKBAKBA GTIChili publish4Over

        What's Going On

        Collapse

        There are currently 4236 users online. 99 members and 4137 guests.

        Most users ever online was 6,151 at 11:36 AM on 11-17-2017.

        Working...
        X