Standard Finishing
4Over

Announcement

Collapse
No announcement yet.

Diagonal registers icons desapeared !!!!!!

Collapse
CanonKonica Minolta
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Diagonal registers icons desapeared !!!!!!

    Hi,
    on my cpc 1 i have lost command icones for the diagonal registers on two groups,
    how can i get them back??
    Attached Files

  • #2
    My guess... when you powered up, those 2 cocking motors failed the init test, so CPC will not recognize they exist when it loads. When CPC started up, what screen did it display? Did it say SSK at the top and have a number blinking below?

    Comment


    • #3
      Hi sir
      Please see his email
      Let me know
      superchock@yandex.com
      cell+WhatsApp:+50588611441

      Comment


      • #4
        Hi,
        The CPC boot normaly without any blinking number.
        When i exchange motors connectors inside the cpc and switch it up, nothing happend except that i can control the exchanged motor from the other group.

        Comment


        • #5
          Dear Sir:
          I saw you have a lot of trouble, but relax.
          1) Please try to replace 3 digit display board, the 7 segment display can be defective.
          1a) Try to test the voltage a lamp, a replace lamp or button,make continuity test with a DMM.
          2) check the connecting cables againts the interconnection cables.
          3)replace the P.C.B or control board too.
          Let me know.
          Blessing.
          superchock@yandex.com
          cell+whatsApp: 505 88611441

          Comment

          4OverStandard FinishingDuploSmartsoft (Presswise)CanonKBAUltimate
          4OverStandard FinishingDuploCanonKBAKBAChili publish4 PeesSmartsoft (Presswise)

          What's Going On

          Collapse

          There are currently 4775 users online. 95 members and 4680 guests.

          Most users ever online was 6,597 at 10:25 AM on 04-20-2018.

          Working...
          X