Standard Finishing
4Over

Announcement

Collapse
No announcement yet.

QM46-2 gear damage

Collapse
CanonKonica Minolta
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • QM46-2 gear damage

    We have had significant damage to the gears on non-operator side of Unit 2 of our QM46-2 press....metal shavings everywhere. We purchased a second press and within 30 days the exact same gears were destroyed on that press as well. Has anyone experienced this and what did you find the cause to be? We have already made sure the floor is level, the unit has substantial grease on the gears, no new chemicals, plates, or other materials, we have very experienced press operators...not sure what could cause the damage, but I need to figure it out before we invest in more expensive repairs.

  • #2
    Dear Sir:
    Hi hope you are well
    You must check the meshing (tooth in tooth space) of cylinder gear to each other..
    The machine some time, must be repair, and was bad adjustment and with that Result.
    Need a mechanical o service manual.
    Let me know
    Blessing
    superchockc@yandex.com
    cell+WhatsApp: +505886114413
    Managua, Nicaragua. C.A.

    Comment

    4OverStandard FinishingDuploSmartsoft (Presswise)AleyantCanonKBA
    4OverStandard FinishingDuploAleyantCanonGraph ExpoLabelexpoKBAKBASmartsoft (Presswise)Chili publish4 Pees

    What's Going On

    Collapse

    There are currently 4537 users online. 104 members and 4433 guests.

    Most users ever online was 6,597 at 10:25 AM on 04-20-2018.

    Working...
    X