Standard Finishing
4OverXerox

Announcement

Collapse
No announcement yet.

Lotem punches bad

Collapse
Canon
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Lotem punches bad

    We have a bad punch in our Lotem 800.
    Anyone know if there's a way to shut off the punches in software?

    Thanks

  • #2
    Yes, you can do that via the Lotem software, but it may be easier to just unplug its' power cable.

    Comment


    • #3
      You should be able to turn the punching off in your workflow.
      If you're exposing through Xpo, change your templates to not include punching
      If you use another workflow, there will be a setting for punch type

      Comment


      • #4
        I tried unplugging the punches, Lotem just stops and gives an error. I also deselected punches in Xpo but still get error about punches.
        Where is it in Lotem software to turn off the punches on the Lotem. I can't locate it.

        Thanks

        Comment


        • #5
          Go to Utilities>Hardware>Punch system>Punch system i think you can turn it off from there or try Utilities>Hardware>Loading system>Loading system>Select punch for loading, hope that helps

          Comment


          • #6
            We were able to remove the punch and give it some TLC with a grinder to get it moving again. So far so good.
            (Never did get the punches to turn off though)

            Comment


            • #7
              We never had to resort to anything that drastic.
              Aligning the detector usually fixed problems.
              BTW, turning off the punches altogether may probably be done in the registry but I don't remember details.

              Comment


              • #8
                Originally posted by Manprint View Post
                Go to Utilities>Hardware>Punch system>Punch system i think you can turn it off from there or try Utilities>Hardware>Loading system>Loading system>Select punch for loading, hope that helps
                Tried that, but it did not shut off punches

                Comment


                • #9
                  Hi Mark
                  Still need help with your Lotem.
                  I fully support those. Where are you located ?

                  Comment

                  4OverDuploCanonKBATharsternAvantiXeroxSmartsoft (Presswise)

                  Presswise Article

                  Collapse

                  Automated Order Status Tracking
                  In PressWise Workflow Solution


                  Presswise order status
                  Quick overview of the order status tracking feature on PressWise’s automated workflow solution

                  Link to Video

                  4OverDuploCanonKBAAvantiXeroxTharsternSmartsoft (Presswise)

                  What's Going On

                  Collapse

                  There are currently 6104 users online. 121 members and 5983 guests.

                  Most users ever online was 6,611 at 11:23 AM on 02-27-2019.

                  Working...
                  X