YoungWolf7
New member
Here's the problem: 2 of our Heidlebergs are perfectors. With our old Brisque workflow we used InkPro. The presses require the CIP3 data to be swapped A<>B as the B side runs first, then the A. It was a simple manual operation in InkPro, but for the life of me I can't figure out how to accomplish the same thing In Prinergy with PrintLink. We can't be the only plant out there running perfecting presses with PrintLink. Anyone have any experience/ideas/solutions with this issue?
Edited by: Dan on Oct 11, 2007 3:20 PM
Edited by: Dan on Oct 11, 2007 3:20 PM