Standard Finishing
4Over

Announcement

Collapse
No announcement yet.

New to Prinergy_Yikes!

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • New to Prinergy_Yikes!

    Hello to all.

    We are switching over from Rampage to Prinergy. It hasn't been easy.
    I am trying to get the plate color info to come out in order (not stacked on top of each other)
    by using the $[colorOnSurface] but it is registration. What the heck? Real easy in Rampage.
    Today I did a small job and it went smooth, but after re-doing it at a lower Proof Resolution the color bar is gone! Why? Lots of problems! Please help!

    Danny

  • #2
    Re: New to Prinergy_Yikes!

    Hi Danny,

    Use $[color_offset] as your variable. I assume you are using a recent version of Prinergy as this mark is only in 3.1.0.3 and up.

    Cheers,
    Rob Morgan
    Kodak

    Comment


    • #3
      Re: New to Prinergy_Yikes!

      Hey Rob, Thank You!!! That is SUCH a big help! Evo 4 seems to need a pdf of your marks as well as an eps too, that is what was wrong with our color bar. Again, Thank you so much!

      Danny

      Comment

      UltimateDuploSmartsoft (Presswise)Standard FinishingKBA4Over
      UltimateDuploStandard FinishingKBAKBA GTIChili publish4Over

      What's Going On

      Collapse

      There are currently 3560 users online. 81 members and 3479 guests.

      Most users ever online was 6,151 at 11:36 AM on 11-17-2017.

      Working...
      X