Standard Finishing
4Over

Announcement

Collapse
No announcement yet.

G7 Calibration

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • G7 Calibration

    We did a G7 calibration run last summer and have been running that way ever since with good results. We are still a film based workflow, what I found interesting was that after tweaking the densities on press to achieve gray balance and then figuring and applying the appropriate curves to meet the G7 tone curve, basically what we end up with, within 1-2 points, is linear plates.

    Anyone else have this same result? I mean it looks like its close enough you could just image linear plates and gray balance on press and be within the tolerances?

    Just wondered,
    Terry

  • #2
    Re: G7 Calibration

    To help here I'd like to know what line screen your running?

    Comment

    UltimateDuploSmartsoft (Presswise)Standard FinishingKBA4Over
    UltimateDuploStandard FinishingKBAKBA GTIChili publish4Over

    What's Going On

    Collapse

    There are currently 4922 users online. 105 members and 4817 guests.

    Most users ever online was 6,151 at 11:36 AM on 11-17-2017.

    Working...
    X