Hi everyone.
I have not been here for a while, so I do not know if somebody posted problem like mine.
I had installed Screen's EP-B101 box on Screen Plate Rite 8300S. After each plate I have to press load, I do not know how to change this.
Until now I approved some job and ctp always asked for another plate until entire job is done.
Does anybody had problem like this?
I have not been here for a while, so I do not know if somebody posted problem like mine.
I had installed Screen's EP-B101 box on Screen Plate Rite 8300S. After each plate I have to press load, I do not know how to change this.
Until now I approved some job and ctp always asked for another plate until entire job is done.
Does anybody had problem like this?