Standard Finishing


No announcement yet.

Flexo repeat counts on press?

  • Filter
  • Time
  • Show
Clear All
new posts

  • Flexo repeat counts on press?

    So, I'm fairly new to printing, and I'm learning to operate a Mark Andy XP5000 that was originally a prototype. So, my question is, when i set up my pre determined counts on the press, and then it comes to a stop because the count has been met, where is this count happening? Is it at the die station and everything that has been die cut is in the count, or from the last print station or what? This press is kind of old, and I just can't figure it out. Any help is appreciated!
KBAAvantiSmartsoft (Presswise)DuploXerox4OverCanon

Zero Setup Time


Zero Setup Time:
Myth Or Reality?

As the twenty-first century opened, Koenig & Bauer had already anticipated the need for the coexistence of conventional and digital printing, and had begun to develop the technology that is today empowering offset printers to meet those challenges.

Read the Article.

What's Going On


There are currently 10904 users online. 130 members and 10774 guests.

Most users ever online was 14,674 at 05:29 AM on 10-30-2019.