I just install 4 new printhead on my jv3-250, did all the head alignment nice and good on all normal and variable dot, but when i do test print on 360x720 bi-direction, variable dot in high speed, the line can not align well, if I do this in uni then it is ok, but my question is what might cause this type of error on the mimaki?
so far only 720x720 bi var high speed is ok but before the new head, I don't has this problem.
thanks.
so far only 720x720 bi var high speed is ok but before the new head, I don't has this problem.
thanks.