Hello I am getting an a verification fail recently on jobs that seem to be over 24 inches long. When I crop the file down it passes. back to full length it fails again. Same file in the RIP que.
I have attached the verification fail that was cut off of a 30 inch piece. In the same image there is the cropped printout with the verification pass.
This has never been an issue until last week. I thought it was a fluke thing on a job that was almost 40 inches. we do not do larger then 8.5x11 most of the time. so I cannot be specific when this started happening.
I looked in the system management and nothing has changed.
As I am typing this I am going to restart. But I won't know if it will fix it until I run another long proof.
Any thoughts?
I have attached the verification fail that was cut off of a 30 inch piece. In the same image there is the cropped printout with the verification pass.
This has never been an issue until last week. I thought it was a fluke thing on a job that was almost 40 inches. we do not do larger then 8.5x11 most of the time. so I cannot be specific when this started happening.
I looked in the system management and nothing has changed.
As I am typing this I am going to restart. But I won't know if it will fix it until I run another long proof.
Any thoughts?