Recent content by Armya Inc

I doubt you should replace the Aprature ٫ appreture motor or the sensor. At least not for now. Open the Allen screw inside the appreture Assy and release the Motor Shaft. Turn the shaft back till the flag is partially outside tye sensor. Clean the sensor and tight the shaft. Note: It is hard to...

I just feel you should consider a few things: 1- If the computer has any issues? 2- delete Agfa Folder. 3- Do the installation. Are the installation DVD is ok?

Did you understand what to do now? The assembly called Mag Motor Assembly. It comes with a Lense, sensor, and a motor. There is no cleaning should be done on the motor. You should clean the lense Only. ​ ​​​​​​While removing the Top cover clean the GLV as well. You have work to do!! Get...

So do it! Take the cover off and look inside the imager from the Top. You will find a lense inside that need to be reached and cleaned. The lense is called Magnification Lense. Alignment should be done on the 12 Mil plate. Have you ever worked on the imager? Then, What did you align on the...

Hi, The phenomina is called the banding issue. Are you using 3.8mm chinise plates? Have you done Magnification (Mag ) motor Alignment? Clean the Mag motor first and do the Mag alignment on 12 mil plate following the procedure in the manual.. You will find thin white and black lines on the...

Why not thinking simple: I removed my comments, I thought it was Avalon LF. If the chiller is on 20 that is fine. Ignore the comment on the interlock. Do you get the Autofocus Controller fault during boot up sequence or the machine completes the sequence? Farshad [email protected]

Get to it and clean it. Easy as thatthat if you feel the sensor has issue. But how about the buffer. Could be the brake on the buffer motor. Have you tight the screw on it? It could be loose.

Do not you want to tell me what model of imagesetter are being used or this is your secret and can't be shared ?

Have you tried the processor in offline mode? Have you noticed the same result? Isn't it the process signal from imagesetter is being sent to processor? The manual clearly explains the sensors and how they will be checked. Good luck . Farshad What else did you do? Good luck.

Andrew, I have never received or missed your email. My email: farshad@army a services. com or +1(416)706-5473. Farshad Armya INC .

Still Available worldwide. Not to mention Agfa has exclusive right on it.

Avdiag is only uned for Avantra Imagesetters..

Phoenix needs Unidiag and not Avdiag. Avdiag is for Avantras Only. The configuration of cable is different too. Farshad [email protected].

Replace the Spinner Motor. I have one like new for $2500 USD. Contact: [email protected] for more info.

Wow. Great. You did it. . But that had to be checked before considering DEC.