Recent content by Broncos100

Did you get a 12000 or 14000? If so, I'm curious how they are doing for you?

We use Eastside Saw for sharpening and new blades. They are in the Pacific NW. https://eastsidesaw.com

I just sent you a message, but it sounds like something we can do depending on size/qty.

We have been having an issue for 2 years and it's getting worse. The slitter will slit sheets as they pass through that section of the machine. The pieces being slit build up and create a jam that requires a technician visit. The technician pulls the slitter unit out of the machine, cleans...

If its like the 618...In the "layout" section, make sure you are using "center" and not "manual". If in manual, it will start cutting where it has been set. If in center, it will assume the artwork is centered on the sheet and cut accordingly.

We're trying to find a new source for printing and pharmaceutical folding, preferably a source that does both in house. We have been using a local business for this service for the past 10+ years and unfortunately this business is closing. We still have an option, but wanted to see what else...

I was just wondering the same thing. We're in the PNW and use WCP, but there prices are way higher based on what's being posted on this thread.

We normally use the "Group" feature on our Fiery to accomplish this. If you have a 3-part NCR, you can print 3 copies using "Group" and it will print 3 copies of each page of the PDF in order.

The thing I find most frustrating is the big guys never seem to have paper issues. We can't get 12pt, 14pt or 16pt and our paper vendor doesn't even know when they will be available again. But...4over and GotPrint never run out of that paper. You can go order BCs or PCs right now and no...