Recent content by Emtri

I would recommend asking your sales rep for a list of specs on the two machines. but basically the engine is going to be the same, finishing equipment and rip related hard/softwear is where the majority of the differences are going to be

I would try Increasing the front/back density. Have not used c6000 but 6501 its under expert adjust/process adjust

Have you tried swapping grain direction or lowering the fuser temp? (I've never run a Ricoh machine) You may not be able to get away with no curl. The nature of digital is applying heat to the paper, which can cause curl. What exactly is the end application of what your trying to do here...

No it definitely exists. But for some reason its like pulling teeth to get the thing...We had a copy of it. I'll try and find

While this is an option in service mode, the same option is available in the tray settings options for each tray. There is a upper and lower fusing temp adjustment (print and idle) for each tray, however the adjustment overall is pretty minor and may not solve any of the issues you may be having...

Are you trying to run it as 300 GSM? if so it wont let you print Tray 4 (PFU) will only go up to 256 gsm, just adjust your settings and it should run.

There are, I am sure a few in whatever area you are in. Off hand I dont know any companies that go past the local market.

My memory of what parts are in the ccd assembly and so forth is a bit rusty, but it sounds like it is the home prehaps something under the glass was bumped out of place. Usually when a sensor cant find something within X time, it throws an error code. Also if a sensor is disconnected or bad...

Does the lamp assembly light up or move when the machine is turned on? Do you know the service history of this machine? Assuming there wasn't some pre existing issue, I too doubt its a board. Have you guys tried reseating all the connectors all the related boards. I would also check the writing...

This error is still happening? Is it coding out all the time? or just once and a while. It sounds to me like a something got bumped loose during the move, Connectors or something the scanner. Do you know what was replaced?

Your best bet is to contact whomever you purchased your printer from and see if they can help you.

As a konica tech...this is new one. Its definitely not your rip of files. It wouldnt be the fuser. My guess would be the magenta write unit or one of the boards..maybe a reg sensor or something? You said they've already replaced a lot though Do you know exactly which boards have been replaced...

Would you be able to post some pictures of sheets with some of your issues?

Here is the link for the engine specs that KM used to get the 8000 certified http://files.idealliance.org/Certifications/DigitalPressCert/DigitalPressADS/EFI_Fiery_%20IC-3600_IC-306_for_Konica-Minolta_bizhub_PRO%AE_C6000_C7000_C8000.pdf Other information and test patterns is here Digital Press...

As a point of interest this is totally normal, The fiery requires a kit in order to be able to use a monitor and keyboard (its like a 2grand purchase) Its much easier to just remote in